Wonderlok’em® Tite Chairs®

Prepare your surface as best you can to ensure the best possible bond with Tite Chairs®. Remove contaminants such as dust, dirt, oil and grime with a solvent such as methylated spirit, acetone, rubbing alcohol (isopropyl alcohol) or lacquer thinner. Mild detergent solution in water is also good for removing contaminants. Use a clean paper towel or rag for wiping. Do not use white spirit or paint thinner for removing contaminants.

Remove rust and loose paint with sandpaper or wire brush.

Smooth, glossy and shiny surfaces should be roughened using sandpaper to increase adhesion.

There is no need to pull out loose rungs. Put the joints in place as tight as possible before use, Tite Chairs® will penetrate the joint on its own.

You may wish to cover the area surrounding the repair with plastic or foil to catch any drips or overflow.

The Tite Chairs® bottle has a child-safe outer cap. Squeeze to remove. For further guidance (and images) please refer to our usage guide.

No mixing required.

The fine-tip nozzle should be attached while holding the bottle upright. If it is difficult to fit onto the bottle then you may widen the nozzle a little with the tip of a pen (as shown in our usage guide).

Tite Chairs® is a very thin in viscosity and will dispense more quickly than a superglue. Don’t tip the bottle upside down until you’re ready to apply and only squeeze the bottle gently.

Wipe any drips immediately with a dry paper towel.

Tite Chairs® will penetrate and tighten joints within minutes. The chair should be nice and tight within 5-30 minutes.

Hold the bottle in the upright position with the tip on. Squeeze the bottle to expel any product in tip. Wipe outside of tip with a dry paper towel to remove any product, and then release the bottle drawing any remaining product in tip back into bottle. Repeat if needed. Removing the tip and tapping it on a hard surface will remove small amounts of product.

With the tip removed, wipe bottle tip with a dry paper towel and replace the reusable cap. Store the bottle upright.

Clean hands and skin with soap and water.

Like super glue, Tite Chairs® will bond skin. NEVER touch eyes while using the product.

Nail polish remover works well to remove hardened drips of Tite Chairs®.

Tite Chairs® dries clear and is water resistant once cured.